advertisement
Component Installation
Twin Disc, Incorporated
Servo Actuator Installation
The EC300 Control System supports one servo actuated device per control.
The EC300 Control Systems can control either a mechanically shifted transmission, a mechanically controlled throttle, or a mechanically controlled troll valve.
The Servo Actuator can be mounted in any orientation on a flat surface. See
Figure 16 for preferred mounting orientation. The Servo Actuator should be located within the reach of the supplied harness and as close to the engine/ transmission as practical.
Note: The Servo Actuator and Push-Pull Cable Installation process should be read and understood prior to installation of Servo Actuator and related components, to ensure all component mounting positions are located properly and all necessary materials are available for the complete installation.
This section contains the following sub-sections:
Servo Actuator Mounting
Push-Pull Cable Installation Guidelines
Push-Pull Cable Installation Kits for Conductive Vessels
Push-Pull Cable Installation Kits for Nonconductive Vessels z z
Push-Pull Cable Installation z
Mechanically Shifted Transmission
Mechanically Controlled Throttle
Mechanically Controlled Troll Valve
Push-Pull Cable Final Adjustment
46 EC300 Marine Control System Installation Manual #1024168
advertisement
Key Features
- Remote throttle control
- Transmission engagement control
- Engine Sync
- Trolling
- Shaft Brake
- Mechanical Actuator Output
- Transmission Oil Pressure and Oil Temperature Monitoring
- Helm Display
Related manuals
Frequently Answers and Questions
What types of vessels is the EC300 Marine Control System suitable for?
What types of engine/transmission combinations is the EC300 Marine Control System compatible with?
What are some of the special features of the EC300 Marine Control System?
advertisement