Installation Manual

Component Installation

Twin Disc Display Installation

Twin Disc, Incorporated

36

3.

4.

1.

2.

5.

Figure 9. Twin Disc Display

Note: Ensure that all items are located for installation on the dash or control panel before cutting the first hole.

Note: One (1) display is provided as an option for each EC300

Control. Multiple displays may be provided to support multiple control stations.

Note: The Twin Disc Display is designed to mount from the front through a 3.2 to 19 mm (0.125 to 0.75 in.) thick panel

or dash. See Twin Disc Display Mounting Dimensions

(1018791) in Engineering Drawings. The mounting

bracket is installed from the rear. Wiring should be connected while the display is accessible.

Locate a position on the dash or control panel for the display.

Using the appropriate cutting tools, cut a 54 mm (2.125 in.) hole.

Round off any sharp edges and remove any burrs.

Remove the mounting bracket and nuts from the rear of the display.

Ensure that the display will fit in the hole.

EC300 Marine Control System Installation Manual #1024168

Twin Disc, Incorporated

Component Installation

6.

Install gasket on display. (See Twin Disc Display Harness (J9) installation for wiring instructions.)

Insert the display in the dash or control panel.

7.

8.

Attach the mounting bracket and tighten the nuts until the display is firmly secured in the dash.

If applicable, repeat steps 1 through 8 for each additional display.

9.

Refer to Twin Disc Display Harness (J9) Installation for display harness wiring installation.

EC300 Marine Control System Installation Manual #1024168

37