advertisement
Twin Disc, Incorporated
Component Installation
Push-Pull Cable Installation Kits for Conductive Vessels
Quick-disconnect ball joint kits or terminal eye pins with cable clamps for Morse
33 series push-pull cables are available from Twin Disc Incorporated. See
Figure 17 and Figure 18. The dual kit accommodates one end of two cables.
The single kit accommodates one end of one cable. Each Servo Actuator requires a single kit to connect the cable to the Servo Actuator. Refer to Morse
33 Series Cable Mounting Dimensions in Engineering Drawings for additional information.
#10-32 x 0.75 (2)
CLAMP, MORSE P/N 31509
SHIM, MORSE P/N 31538
#12 EXTERNAL TOOTH LOCK WASHER (2)
RETAINER PLATE
Figure 17. Installing Cable Clamp on Servo Actuator for Conductive
Vessels
MORSE BALL JOINT ASSY.
0.218 ID NYLON FLAT WASHER
ACTUATOR ARM
0.218 ID NYLON FLAT WASHER
MORSE LOCK WASHER
MORSE NUT
Figure 18. Installing Ball Joint Assembly for Conductive Vessels
EC300 Marine Control System Installation Manual #1024168
49
advertisement
Key Features
- Remote throttle control
- Transmission engagement control
- Engine Sync
- Trolling
- Shaft Brake
- Mechanical Actuator Output
- Transmission Oil Pressure and Oil Temperature Monitoring
- Helm Display
Related manuals
Frequently Answers and Questions
What types of vessels is the EC300 Marine Control System suitable for?
What types of engine/transmission combinations is the EC300 Marine Control System compatible with?
What are some of the special features of the EC300 Marine Control System?
advertisement