PRIMERGY RX300 S7 Server Upgrade and Maintenance Manual

Basic hardware procedures

4.7

Closing the server

V

CAUTION!

●

Before attaching the covers, make sure no unnecessary parts or tools are left inside the server.

●

●

In order to comply with applicable EMC regulations (regulations on electromagnetic compatibility) and satisfy cooling requirements, the

PRIMERGY RX300 S7 server must not run while the server cover is removed.

For further safety information, please refer to chapter "Important information" on page 41 .

4.7.1

Mounting the server cover

Figure 17: Mounting the server cover

Ê

Open the locking lever on the top cover.

Ê

Fit the server cover on the chassis, aligning it according to the edge guide marking on the upper server surface.

Ê

Lower the server cover onto the chassis.

RX300 S7

Upgrade and Maintenance Manual 73