PRIMERGY RX300 S7 Server Upgrade and Maintenance Manual

Front panel

13.1.3 Removing the front panel module

Figure 235: Disconnecting the front panel cable

Ê

Disconnect the front panel cable from the system board.

Ê

If applicable, disconnect the front VGA cable from the system board see

section "Removing the front VGA cable" on page 408

.

396 Upgrade and Maintenance Manual

RX300

Front panel

Figure 236: Disconnecting front panel cables

Ê

If applicable, disconnect the front LAN board from the system board:

Press in on the locking latch on the front LAN board holder (1) and pull the front LAN board holder with the front LAN board out of its socket (2).

RX300 S7

Upgrade and Maintenance Manual 397

Front panel

Figure 237: Removing the front panel module

Ê

Push in on the locking latches upward (1) to disengage the locking mechanism.

Ê

Carefully pull the front panel module out of its bay (2).

V

CAUTION!

Ensure that none of the cables are strained or damaged!

Ê

If the front VGA connector has been installed in the defective front panel

module, remove the cable as described in section "Removing the front VGA connector" on page 409 .

Ê

If the front LAN connector has been installed in the defective front panel

module, remove the cable as described in section "Removing the front VGA connector" on page 409 .

398 Upgrade and Maintenance Manual

RX300