PRIMERGY RX300 S7 Server Upgrade and Maintenance Manual

Hard disk drives / solid state drives

Ê

Insert the HDD module into a drive bay and carefully push back as far as it will go (1).

Ê

Close the locking lever to lock the hard disk drive in place (2).

7.3.2.5

Concluding steps

Perform the following procedures:

Ê

"Performing a RAID array rebuild" on page 107

Ê

"Closing the rack door" on page 81

7.3.3

Removing 2.5-inch HDD / SSD modules

Customer Replaceable Units (CRU)

Average task duration: 5 minutes

●

●

7.3.3.1

Required tools

Preliminary and concluding steps: tool-less

Removing a 2.5-inch HDD / SSD module: tool-less

7.3.3.2

Preliminary steps

Perform the following procedures:

Ê

Ensure that the HDD / SSD module to be removed is not combined into a

RAID array. If the drive is part of a RAID array, you first need to delete the array using ServerView RAID Manager.

V

CAUTION!

All data on all HDDs / SSDs in the array will be lost! Be sure to back up your data before deleting a RAID array.

I

For further information, please refer to the "ServerView Suite RAID

Management" user guide, available online at

http://manuals.ts.fujitsu.com

or from the ServerView Suite DVD 2 supplied with your PRIMERGY server.

148 Upgrade and Maintenance Manual

RX300