2.9.14 SLC Wiring with an NBG-12LX Addressable Manual Pull Station. Notifier AFP-200

Installation

Wiring a Signaling Line Circuit (SLC)

3. Set the detector address on the head with a small, slotted screwdriver. Mark this address on the base and on the head.

4. Install the intelligent detector head.

Wiring an Intelligent Detector to an SLC

Figure 42 shows typical wiring of a detector (wired to a RA400Z remote annunciator) connected to an SLC:

SLC

Channel (+)

Channel (–)

Channel (+)

Channel (–) to next device on SLC

Detector Base

RA400Z Remote

LED Annunciator

Figure 42 Typical Wiring of a Detector Base to an SLC

2.9.14 SLC Wiring with an NBG-12LX Addressable Manual

Pull Station

The NBG-12LX is an addressable manual pull station with a key-lock reset feature.

Figure 43 shows typical wiring and provides instructions for setting the SLC address.

1. Connect the SLC to terminal screws (+) and (–).

2. Connect the NBG-12LX to the CPU as shown in Figure 43.

3. Set the SLC address of the pull station. Rotary switches are located on the interior of the pull station, as shown in Figure 43. The address is set the same way as for control, monitor & relay modules (refer to “Setting an SLC Address for a Module” on page 44). Factory preset is address 00. Record the device address and SLC number on the label inside the pull station.

Note: In the sample shown below, the switches are set to address 12.

60

Technical Manuals Online! - http://www.tech-man.com

AFP-200 PN 15511:H2 10/14/2002