Mounting the Charger into a Battery Box. Notifier AFP-200

External Battery Charger

Mounting the CHG-120

Mounting hooks

Position 1:

Lower right corner.

Position 2:

Lower left corner.

Figure 169 Mounting a Charger into a CAB-X3 (CAB-C3 shown)

To mount a charger into a CAB-X3 Series Cabinet, follow these instructions:

1. Place the charger chassis mounting slots in line with the mounting holes in the cabinet. If mounting in position 2, place the charger chassis onto the mounting hooks in the cabinet.

2. Insert the self-tapping screws through the charger chassis mounting slots and into the mounting holes in the cabinet.

Self-tapping screw

Chassis mounting slot

3. Tighten the self-tapping screws.

N.3.2 Mounting the Charger into a Battery Box

You can also mount a charger into a BB-55 or NFS-LBB battery box, as long as the box is within 20 feet (6.096 m) of the load. Note that a charger takes up half the space of the

192

Technical Manuals Online! - http://www.tech-man.com

AFP-200 PN 15511:H2 10/14/2002

Mounting the CHG-120

External Battery Charger battery box. This means there is only room left for two 25 AH batteries in the BB-55 or NFS-LBB.

Figure 170 shows the mounting position.

Optional bracket for mounting an optional

AM-1 or VM-1

Self-tapping screws

Figure 170 Mounting a Charger into a BB-55 or NFS-LBB

To mount a charger into the battery box, follow these instructions:

1. Place the charger chassis mounting slots in line with the mounting holes in the BB-55 or

NFS-LBB.

2. Insert the self-tapping screws through the charger chassis mounting slots and into the mounting holes in the battery box.

Self-tapping screw

Chassis mounting slot

3. Tighten the self-tapping screws.

AFP-200 PN 15511:H2 10/14/2002

Technical Manuals Online! - http://www.tech-man.com

193