B.3 NFPA 72 Auxiliary Fire Alarm System. Notifier AFP-200

NFPA 72 Auxiliary Fire Alarm System

NFPA Applications to 2 (refer to the UDACT manual)?

5. Is the ACS/ TERM switch (SW2) on the control panel set to the ACS position?

6. Is the control panel programmed for “ANNUN=UDACT”?

7. Is the control panel configured for proper supervision? Supervise the UDACT via the COMM FAIL output (refer to Monitoring for UDACT Trouble in the UDACT

Manual)?

• For a system without an annunciator – configure the UDACT for

Receive/Transmit

.

• For a system with an annunciator – configure the UDACT for

Receive Only

and the annunciator for

Receive/Transmit

.

Note: If the annunciator does not require remote control capabilities (Reset,

Acknowledge, Silence, etc.), 'COMM FAIL' monitoring is not required if the following conditions are met: the UDACT is configured for “Receive/Transmit”

and

the annunciator is configured for “Receive Only”.

B.3 NFPA 72 Auxiliary Fire Alarm System

Figure 131 and 131 show typical connections (all connections are nonpower-limited and supervised) for wiring the control panel to a municipal box. Maximum loop resistance allowed for wiring from control panel to Municipal Box is 5 ohms. Cut JP5 on control panel circuit board. This application is not suitable for separate transmission of sprinkler supervisory or trouble conditions.

RTM-8 Module

Gamewell Model M34-56

Local Energy Municipal Box

Jumper JP2 must be in the LE MUNCPL BOX position for use in this application

Municipal Box Circuit

Polarities shown in alarm condition

Figure 131 Wiring a Municipal Box Connected to a RTM-8

AFP-200 PN 15511:H2 10/14/2002

Technical Manuals Online! - http://www.tech-man.com

135