Local Monitor Mode (LocM). Notifier AFP-200

Terminal Interface Protocol

Operating Modes

Table 62 below summarizes the functions available with the Local Terminal mode:

Function

Read Status

Alter Status

Control

Functions

Lets you...

• Display the status of an individual point (detector, module, panel circuit, or zone)

• Display a list of all the points in alarm or trouble

• Display a list of all programmed points in the system

• Step through the history buffer event by event

• Display the entire history buffer

• Disable/Enable an individual point

• Change the sensitivity of a detector

• Clear the verification counter of all detectors

• Clear the entire history buffer

• Set the AWACS™ alert and action levels

• Acknowledge

• Alarm Silence

• System Reset

• Drill

Table 62 LocT Functions

I.2.2 Local Monitor Mode (LocM)

Functions, passwords, and special requirements of Local Monitor Mode (LocM) are:

Functions:

Read Status, Alter Status, and Control Functions.

Passwords:

User-defined password for Alter Status and Control functions.

Requirements:

Password security feature for Control Functions eliminates the need for mounting the CRT-2 in an enclosure.

Table 63 summarizes the functions available with the Local Monitor mode:

Function Lets you...

Read Status • Display the status of an individual point (detector, module, panel circuit, or zone)

• Display a list of all the points in alarm or trouble.

• Display a list of all programmed points in the system

• Step through the history buffer event by event

• Display the entire history buffer

Alter Status*

Control

Functions*

• Disable/Enable an individual point

• Change the sensitivity of a detector

• Clear the verification counter of all detectors

• Clear the entire history buffer

• Set the AWACS™ alert and action levels

• Acknowledge

• Alarm Silence

• System Reset

• Drill

*Requires the user defined password for access.

Table 63 LocM Functions

I.2.3 Remote Terminal Mode (RemT)

Functions, passwords, and special requirements of Remote Terminal Mode (RemT) are:

Functions:

Read Status only. See Table 64.

170

Technical Manuals Online! - http://www.tech-man.com

AFP-200 PN 15511:H2 10/14/2002