Seats. Ford S-MAX, Galaxy

PDF

Dokumen

Seats

SITTING IN THE CORRECT

POSITION

• bend your legs slightly so that you can press the pedals fully.

• position the shoulder strap of the safety belt over the center of your shoulder and position the lap strap tightly across your hips.

Make sure that your driving position is comfortable and that you can maintain full control of your vehicle.

HEAD RESTRAINTS

Adjusting the head restraint

WARNINGS

Raise the rear head restraint when the rear seat is occupied by a passenger.

seat.

When using a forward facing child restraint on a rear seat, always remove the head restraint from that

WARNINGS

Do not adjust the seats when the vehicle is moving.

Only when you use the safety belt properly, can it hold you in a position that allows the airbag to achieve its optimum effect.

When you use them properly, the seat, head restraint, safety belt and airbags will provide optimum protection in the event of a collision. We recommend that you:

• sit in an upright position with the base of your spine as far back as possible.

• do not recline the seatback more than

30 degrees.

• adjust the head restraint so that the top of it is level with the top of your head and as far forwards as possible, remaining comfortable.

• keep sufficient distance between yourself and the steering wheel. We recommend a minimum of 250 millimeters (10 inches) between your breastbone and the airbag cover.

• hold the steering wheel with your arms slightly bent.

Adjust the head restraint so that the top of it is level with the top of your head and as far forwards as possible, remaining comfortable.

126

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

Removing the head restraint

Press the locking buttons and remove the head restraint.

MANUAL SEATS

Moving the seats backwards and forwards

Adjusting the lumbar support

Adjusting the height of the driver’s seat

WARNING

Rock the seat backwards and forwards after releasing the lever to make sure that it is fully engaged in its catch.

127

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Adjusting the angle of the seatback

Seats

POWER SEATS

2-way power seat

128

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

8-way power seat

Seats

129

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

REAR SEATS

Second Row Seats

Moving the Seats Backward and

Forward

WARNING

Rock the seat backward and forward after releasing the lever to make sure that it is fully engaged in its catch.

Adjusting the Seatback

To recline the seatback, pull the lever on the outboard seats or the strap on the center seat and lean back against the seatback until it reaches the desired position.

To raise the seatback, pull the lever up and push the seat cushion forward using your weight.

Easy Entry Position (Vehicles with

Third Row Seats Only)

Note: You can move the outboard seats forward to allow access to the third row seats.

130

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

Pull the lever once. Fold the seatback forward into the position shown and slide the complete seat forward.

5. To move the seat further back, pull the lever under the front of the seat and slide it backward.

Folding the Seatbacks Down

WARNING

When folding the seatbacks down, hold the seatback to avoid getting your fingers caught between the seatback and seat frame.

Lower the head restraints. See Head

Restraints (page 126).

2. Slide the seats backward as far as they will go.

3. Insert the center safety belt into the

retainer in the roof. See Fastening the safety belts (page 30).

2. When exiting your vehicle from the third row seats, pull the loop on the rear of the second row seat.

3. To return the seat to the seating position, slide the seat backward. The seat will stop automatically and at a midway position.

4. Fold the seatback up until it engages.

4. On the outboard seats, pull the lever and fold the seatback into a sloped position.

131

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

5. Pull the lever again and fold down the seatback.

6. On the center seat, pull the loop between the seat cushion and the seatback and fold down the seatback.

To engage the seatbacks in the folded position, pull the lever or loop again and push the seatback firmly down until it latches into position.

To return the seat to the seating position, pull the lever or loop and fold the seatback up until it engages.

Third Row Seats

WARNING

Do not sit in a third row seat when the second row seat in front of it is folded flat.

Moving the Seats Backward and

Forward (Galaxy)

WARNING

Rock the seat backward and forward after releasing the lever to make sure that it is fully engaged in its catch.

Adjusting the Seatback (Galaxy)

To recline the seatback, pull the strap and lean back against the seatback until it reaches the desired position.

To raise the seatback, pull the strap and let the seatback return to the upright position.

132

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

Folding the Seats Flat

WARNING

When folding the seatbacks down, hold the seatback to avoid getting your fingers caught between the seatback and seat frame.

Pull loop A at the rear of the seat cushion.

3. To return the seat to the seating position. Fold the carpeted cover back, grasp the grip (B) and pull the seatback upward and then rearward.

4. Fold the seat cushion back and lock in to position.

Creating a Level Load Floor

WARNING

When transporting a load with the seats folded flat, always fold the relevant carpeted cover forward to cover the folded seats.

2. The seat cushion will automatically turn over and lie flat on the floor (1).

The seatback will automatically fold down.

133

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

The carpeted cover is held in position by magnets, fold the carpeted cover forward to cover up the folded seats.

Note: When only the third row seats are folded flat, fold the covers forward to cover up the base of the second row seats. The smaller flaps at the front of the cover should stand vertically against the second row seatbacks.

HEATED SEATS

Note: Operating this function with the engine off will drain the battery.

Note: The number of illuminated lights beside the button indicates the selected step.

Note: The heater setting is indicated in red.

Note: When no light is illuminated, the heating is switched off.

Note: Only the front seat settings are stored when you switch off the ignition.

Raising and Lowering the

Temperature

Press and hold the relevant button or press it repeatedly to select the desired temperature.

VENTILATED SEATS

Note: Operating this function with the engine off will drain the battery.

134

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Seats

FRONT SEAT ARMREST

Note: The number of illuminated lights beside the button indicates the selected step.

Note: The ventilation setting is indicated in blue.

Note: When no light is illuminated, the ventilation is switched off.

Note: The settings are stored when the ignition is switched off.

Note: When the seat is being ventilated, the heater may switch on automatically.

This is to prevent the flow of air becoming uncomfortably cool.

Note: The air in the vehicle interior is used to ventilate the seats. The cooling effect therefore depends on the temperature of the vehicle interior. Switch on the air conditioning if necessary and set the air

distribution to footwell. See Climate

Control (page 112).