Audio unit operation
ON/OFF CONTROL
Press the on/off control. This will also operate the unit for up to one hour with the ignition turned off.
The radio will switch off automatically after one hour.
BASS/TREBLE CONTROL
The bass function is used to adjust the low-frequency response of the audio unit.
The middle function is used to adjust the mid-frequency response of the audio unit.
The treble function is used to adjust the high-frequency response of the audio unit.
6000CD
Note: The selected level will be shown in the display.
1.
Press the SOUND button once for bass, twice for middle or three times for treble.
2. Use the volume control or on some units the seek up or seek down button to make the necessary adjustment.
Sony and Sony DAB
Note: You can adjust these settings separately for CD, Radio and Aux.
Note: The selected level will be shown in the display.
1.
Press the TONE button once for bass, twice for middle or three times for treble.
2. Use the up and down navigation buttons to make the necessary adjustment.
BALANCE/FADE CONTROL
The balance function is used to adjust the sound distribution between the left and right speakers.
The fade function is used to adjust the sound distribution from front to rear in vehicles fitted with rear speakers.
6000CD
Press the SOUND button four times for balance or five times for fade.
Use the volume control or on some units the seek up or seek down button to make the necessary adjustment.
Sony and Sony DAB
Press the FAD/BAL button once for fade or twice for balance.
Use the up and down navigation buttons for fade adjustment, and the left and right navigation buttons for balance adjustment.
The selected level will be shown in the display.
AUDIO MENU CONTROL
Use the MENU button to access functions that cannot be selected directly via one of the control buttons. Press the MENU button for first level functions, or press and hold the MENU button for other second level functions (not available on Sony or
Sony DAB audio units).
277
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Audio unit operation
6000CD
Menu functions
First level Second level
During radio reception
Manual tuning
During tape playback During CD playback During all functions
12/24 hour Scan Traffic local or distant
Scan tuning
12/24 hour
AVC
*
ADV menu
-
Shuffle
Repeat
Comp
AF
**
REG
News
AVC
*
ADV menu 12/24 hour CLIP
-
AVC
*
VID
ADV menu Bluetooth enable/ disable
Note: The sequence in which functions appear may vary for different audio units and vehicles.
Note: Second level functions (advanced) can also be entered by selecting ADV menu from the first level menu.
* Automatic volume control.
** Alternative frequencies.
Sony CD and Sony CD DAB
Menu functions
During radio reception
12/24 hour
CLIP ON/OFF
News ON/OFF
AVC
1
AF 2
During CD playback
12/24 hour
CLIP ON/OFF
News ON/OFF
AVC
1
AF 2
278
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Audio unit operation
Menu functions
During radio reception During CD playback
TA
3
volume
Traffic local or distant
Regional ON/OFF
TA
3
volume
Traffic local or distant
Shuffle
Repeat
Comp ON/OFF
Note: The sequence in which functions appear may vary for different audio units and vehicles.
1
Automatic volume control.
2
Alternative frequencies.
3
Traffic announcement.
Sony CD and Sony CD DAB with
Bluetooth
Pressing PHONE followed by the MENU button will access the following options:
• No active phone or Active phone
• Debond BT device
• Reject calls ON/OFF
• Bluetooth ON/OFF.
This can be repeated on each waveband and for each preset button.
Note: When you drive to another part of the country, FM RDS (Radio Data System) stations that broadcast on alternative frequencies are stored on the preset buttons.
WAVEBAND BUTTON
Note: The selector can also be used to return to radio reception when you have been listening to another source.
Press the RADIO button to select from the wavebands available.
STATION PRESET BUTTONS
This feature allows you to store your favorite stations so that they can be recalled by selecting the appropriate waveband and pressing one of the preset buttons.
1.
Select a waveband.
2. Tune to the station required.
3. Press and hold one of the preset buttons. The audio unit will mute.
When sound returns the station has been stored.
AUTOSTORE CONTROL
Note: This function will overwrite the previously stored autostore preset stations.
Note: This function can also be used to store stations manually in the same way as other wavebands.
Note: The strongest signals available on the selected waveband will be stored.
279
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Audio unit operation
The sound is muted and AUTOSTORE will be shown in the display while the unit searches through the frequencies.
When the search is complete, sound is restored and the strongest signals are stored on the autostore presets.
6000CD
Press and hold the RADIO button.
Sony CD
Press and hold the AST or RADIO button.
TRAFFIC INFORMATION
CONTROL
Many stations that broadcast on the FM waveband have a TP code to signify that they carry traffic program information.
Activating traffic announcements
Before you can receive traffic announcements, you must press the TA button. Either TA-D or TA-L will be shown in the display to indicate that the feature is switched on.
If you are already tuned to a station that broadcasts traffic information, TP will also be shown in the display. Otherwise the unit will search for a traffic program and display
TP SEEK while doing so. If it cannot locate such a station, NOT FOUND will be shown in the display.
TP will be shown within a box in the display when you are tuned to a station providing traffic information from a linked RDS (radio data system) or EON (enhanced other network) station.
When traffic information is broadcast, it will automatically interrupt normal radio, tape or CD playback and TRAFFIC or
NEWS will be shown in the display.
If the traffic signal weakens, TP will flash in the display. Press the seek up or seek down button (the left or right navigation button on Sony or Sony DAB audio units) to find another station.
Note: If this happens during CD or AUX playback or, on certain models, with the radio volume set to zero, the unit will retune automatically if the station is not available.
If a non-traffic station is selected or recalled using a preset button, the audio unit will remain on that station unless TA is turned off, then on again.
Note: If TA is on and you select a preset or manual tune to a non TA station no traffic announcement will be heard.
Local or distant traffic
The number of RDS or EON traffic announcements may become excessive in some areas so there is an option to select between local traffic information and all available information.
6000CD
1.
Press and hold the MENU button until the display changes.
2. Press the MENU button repeatedly until TA is shown in the display.
3. Press the seek up or seek down button to select either local (TA LOCAL) or distant (TA DIST) traffic announcements.
4. Press the MENU button or allow the menu to time out to confirm your selection.
Note: Either TA-L or TA-D will be shown in the display.
280
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Audio unit operation
Sony CD
1.
Press the MENU button and use the up or down navigation button to select the TA display.
2. Press the left or right navigation button to select your required setting.
3. Press the MENU button to confirm your selection.
Traffic announcement volume
Traffic announcements interrupt normal broadcasts at a preset minimum level that is usually louder than normal listening volumes.
To adjust the preset volume
6000CD
1.
Press and hold the TA button.
2. Rotate the volume control to make the necessary adjustment.
Note: The selected level will be shown in the display.
Sony CD
1.
Press and hold the TA button.
2. Press the left or right navigation button to make the necessary adjustment.
Note: The selected level will be shown in the display.
Ending traffic announcements
The audio unit will return to normal operation at the end of each traffic announcement. To end the announcement prematurely, press TA during the announcement.
Note: If you press TA at any other time it will switch all announcements off.
STATION TUNING CONTROL
DAB service linking
Note: The DAB service linking is as per default off.
Note: Service linking allows cross-referencing to other corresponding frequencies of the same station, for example
FM and other DAB ensembles.
Note: The system will automatically change to another corresponding station if the current one becomes unavailable, for example when leaving the coverage area.
Switching DAB service linking on and off
1.
Press the MENU button.
2. Using the up or down navigation button scroll through the display until DIGITAL
RADIO SERVICE LINK is shown in the display.
3. Using the left or right navigation button select AUTO or OFF.
4. Press the MENU button or the button between the navigation buttons to confirm your selection.
Seek tuning
6000CD
Select a waveband and briefly press the seek up or seek down button. The unit will stop at the first station it finds in the direction you have chosen.
Sony CD
Select a waveband and briefly press the up or down navigation button. The unit will stop at the first station it finds in the direction you have chosen.
281
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Audio unit operation
Manual tuning
6000CD
1.
Select a waveband and press the
MENU button until MAN is shown in the display.
2. Press the seek up or seek down button to tune up or down the waveband in small increments or press and hold to increment quickly, until you find a station you want to listen to.
Sony CD
Select a waveband and briefly press the up or down navigation button to tune up or down the waveband in small increments. The display shows the frequency selected.
Sony DAB
Note: Ensembles are groups of stations.
Briefly press the up or down navigation button to move up or down the ensembles.
Scan tuning
The SCAN function allows you to listen to
10 seconds of each station detected.
6000CD
1.
Press the MENU button repeatedly until SCAN is shown in the display.
2. Press the seek up or seek down button to scan up or down the selected waveband.
3. Depending on the audio unit, press the seek up or seek down button or the
MENU button to continue listening to a station.
Sony and Sony DAB
1.
Press the SCAN button. SCAN flashes or SCANNING is shown in the display.
2. Press the left or right navigation button to scan within a waveband.
3. Press SCAN again to continue listening to a station.
282
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
