Convenience features. Ford S-MAX, Galaxy

PDF

Dokument

Annonce

SUN SHADES

Side windows

Convenience features

Note: If you operate the switch often during a short period of time, the system might become inoperable for a certain time to prevent damage due to overheating.

Note: The sun blind can only be operated when the ignition is on.

Pull the blind up and attach it to the hooks

( A ).

Roof (Galaxy)

The sun blind is operated by a switch located between the sun visors.

Opening and closing the sun blind

Roof (S-MAX)

WARNING

Do not operate the sun blind unless it is free from obstruction.

Press to close

Press to open

136

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

Opening and closing the sun blind automatically

Press the switch to the second action point and release it. Press it again to stop the blind.

Note: If this does not operate correctly, follow the relearning procedure below.

Anti-trap function

WARNINGS

The anti-trap function is deactivated until the memory has been reset by the relearning procedure.

Careless closing of the blind can override the anti-trap function and cause injuries.

The sun blind will stop automatically while opening or closing and reverse some distance if there is an obstacle in the way.

Sun blind relearning

WARNING

The anti-trap function is not active during this procedure. Make sure that there are no obstacles in the way of the moving blind.

Note: The relearning process must be started no later than 30 seconds after turning the ignition on.

In case the blind no longer opens or closes properly, follow this relearning procedure:

Press switch B to the first action point twice and release it within two seconds.

2. Press switch A to the first action point twice and release it within two seconds.

3. Press and hold switch B to the first action point, until the blind fully opens.

4. Press and hold switch A to the first action point, until the blind fully closes.

If step 2 is not completed within 15 seconds, the relearning function will be interrupted. Turn the ignition off, wait for another 30 seconds and then turn the ignition back on again. Start the procedure once more from the beginning.

Confirm that relearning has been completed by using automatic opening and closing.

INSTRUMENT LIGHTING

DIMMER

CLOCK

Note: Some navigation systems will automatically set the date and time on the clock using GPS signals.

Note:

See General Information (page

89).

From the main menu, select the clock function.

2. Select the option required.

3. Press OK .

4. Using the right, left, up and down arrow buttons, select and change the value.

137

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

5. Press OK .

CIGAR LIGHTER

CAUTIONS

If you use the socket when the engine is not running, the battery may discharge.

Do not hold the cigar lighter element pressed in.

Note: Switch the ignition on to use the cigar lighter. You can also use it for up to 30 minutes after you have switched the ignition off.

Note: You can use the socket to power 12 volt appliances that have a maximum current rating of 15 Amperes. Use only Ford accessory connectors or connectors specified for use with SAE standard sockets.

ASHTRAY

Front ashtray

To empty, pull out the complete ashtray.

Rear ashtray

Press the element in to use the cigar lighter. It will pop out automatically.

To remove the ashtray, open it, press it down against the spring and remove it.

AUXILIARY POWER POINTS

CAUTION

If you use the socket when the engine is not running, the battery may discharge.

Note: You can use the socket when the ignition is switched off.

138

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

S-Max

Seat back trays

WARNING

Do not use the trays when the vehicle is moving. Make sure that you secure the trays in the lowered position before setting off.

Galaxy

CUP HOLDERS

WARNING

Do not place hot drinks in the cup holders when the vehicle is moving.

GLOVE BOX

Cooled glove box

Note: You can cool the glove box using air from the air conditioning system.

139

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

STORAGE COMPARTMENTS

off.

WARNING

Do not drive with any storage compartment lid open. Make sure that you secure the lid before setting

CAUTION

Do not keep heat-sensitive items and liquids in any storage compartment.

Front storage compartments

Under seat storage compartment

140

Overhead storage compartments

WARNING

Do not place heavy objects in the overhead storage compartments.

CAUTION

Do not exceed the maximum permissible loads of 1 kilogram (2.2

pounds) for the smaller compartment and 2 kilograms (4.4 pounds) for the larger compartment.

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

Vehicles with premium sound system

CAUTION

Do not attempt to open the left-hand cover.

MAP POCKETS

Under floor storage compartment

WARNING

If you want to use a child seat with a support leg, consult the child seat manufacturer's website or fitting instructions. You must make sure the child seat is compatible with your vehicle. Check for any special fitting instructions regarding the removal of the under floor storage compartment cover or the position of the

second row seats. See Child Seat

Positioning (page 23).

FOLDING TRAY

WARNING

Do not use the trays when the vehicle is moving. Make sure that you secure the trays in the lowered position before setting off.

141

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

MEMORY FUNCTION

GLASSES HOLDER

Seat adjustment controls

Memory pre-set buttons

Up to four different driver's seat and exterior mirror positions can be stored in the memory. Your preferred setting for the reverse mirror dipping feature can also be stored.

Setting a memory pre-set

Passive setting

The vehicle stores the seating and mirror positions for up to four remote controls or passive keys. Next time the vehicle is unlocked, the position of the seat and mirrors will adjust to the last used position.

Each time you turn the ignition off, the current seat and mirror settings are stored on the remote control or passive key used.

Active setting

Turn the ignition on.

2. Adjust the seat and exterior mirrors to the desired position.

142

Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing

Convenience features

3. Press and hold the desired pre-set button B until a single chime sounds to confirm.

Recalling a stored seat position

Note: To stop seat movement during a recall, press any driver seat adjustment control, any of the memory buttons or any mirror control switch. Seat movement will also stop if you move the vehicle.

Passive recall

Note: If more than one passive key is in range, the memory function will move to the settings of the first key stored.

When you unlock the vehicle with the remote control or pull the driver door handle with a passive key in range, the seat and mirrors will move to the position stored on that remote control or passive key.

Active recall

Press the pre-set button associated with the desired driving position. The seat and mirrors will move to the position stored on that pre-set.

Resetting the memory

If any seat position travel is interrupted

(e.g. an obstacle in the way or loss of power supply), you will need to reset the memory.

Note: Make sure all electrical accessories are switched off.

Turn the ignition to position II .

2. Operate the seat adjustment control to move the seat in the required direction until it stops. A click will be heard.

3. Release the seat adjustment control and immediately press and hold the switch in the same direction for at least

3 seconds. Keep it held until the seat stops at the mechanical end of its travel and a click is heard.

4. Release the seat adjustment control.

5. Operate the same seat adjustment control in the opposite direction for at least 3 seconds. Keep it held until the seat stops at the mechanical end of its travel and a click is heard.