4.5 Installation Procedure. Mitsubishi Electric GT15
विज्ञापन
विज्ञापन
4.5 Installation Procedure
The GOT is designed to be embedded into a panel.
Mount the GOT by following the procedure below.
For panel cutting dimensions, refer to Section 4.2.
Note that the panel thickness should be within 4mm.
(1) Placing into the panel
Place the GOT into the panel from the front.
No
1)
2)
Name
GOT
Mounting hole
1)
2)
(2) Fixing the GOT
Insert mounting fixtures
(included with GOT) into module fixing holes and tighten mounting screws in four upper/lower parts until the GOT will be fixed.
Magnified illustration
No
1)
2)
Name
Mounting fixture
Mounting screw
1)
2)
Tighten mounting screws in the torque range of 0.36 to
0.48N•m.
(Failure to do so may distort the panel and make a surface waviness on the protective sheet.)
(3) A protection film is attached on the display section of GOT prior to shipment.
Remove the film when the installation is compelted.
20
डाउनलोड
विज्ञापन