7 OPERATION

7.1 OWNER/OPERATOR

RESPONSIBILITIES

SECTION 7. OPERATION

• Never attempt to start the engine or

operate the machine except from the windrower seat.

• Check the operation of all controls in a

safe clear area before starting work.

CAUTION

• It is your responsibility to read and

understand this manual completely before operating the header. Contact your

MacDon Dealer if an instruction is not clear to you.

• Follow all safety messages in the manual

and on safety signs on the machine.

• Remember that YOU are the key to safety.

Good safety practices protect you and the people around you.

• Before allowing anyone to operate the

header, for however short a time or distance, make sure they have been instructed in its safe and proper use.

• Review the manual and all safety related

items with all Operators annually.

• Be alert for other Operators not using

recommended procedures or not following safety precautions. Correct these mistakes immediately, before an accident occurs.

• Do not modify the machine. Unauthorized

modifications may impair the function and/or safety and affect machine life.

• The safety information given in this

manual does not replace safety codes, insurance needs, or laws governing your area. Be sure your machine meets the standards set by these regulations.

Follow these safety precautions:

CAUTION

• Follow all safety and operational

instructions given in your Operator's

Manuals. If you do not have a windrower manual, get one from your dealer and read it thoroughly.

• Do not allow riders on windrower.

• Never start or move the machine until you

are sure all bystanders have cleared the area.

• Avoid travelling over loose fill, rocks,

ditches or holes.

• Drive slowly through gates and doorways.

• When working on inclines, travel uphill or

downhill when possible. Be sure to keep transmission in gear when travelling downhill.

• Never attempt to get on or off a moving

machine.

• Do not leave Operator’s station while the

engine is running.

• Stop engine, and remove key before

adjusting or removing plugged material from the machine. A child or even a pet could engage the drive.

• Check for excessive vibration and

unusual noises. If there is any indication of trouble, shut down and inspect the machine. Follow proper shutdown procedure. Refer to Section 7.7

SHUTDOWN PROCEDURE.

• Operate only in daylight or good artificial

light.

Form 169441

22

Revision B