advertisement
SECTION 8. MAINTENANCE AND SERVICING
8.9 REEL AND REEL DRIVE
CAUTION
To avoid personal injury, before servicing header or opening drive covers, follow procedures in Section 8.1 PREPARATION
FOR SERVICING.
8.9.1 REEL CLEARANCE TO
CUTTERBAR
The finger to guard/cutterbar clearances with reel fully lowered varies with header width, and are as follows. See illustration opposite.
‘X’ +/- .12 in. (3 mm) @ ENDSHEETS
HEADER
SINGLE REEL
15 FT.
20 FT.
0.78 in. (20 mm)
25 FT. 1.00 in. (25 mm)
30 FT. 1.77 in. (45 mm)
35 FT. 2.36 in. (60 mm)
40 FT. ---
DOUBLE REEL
---
0.78 in. (20 mm)
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, stop engine, remove key and engage lift cylinder locks before going under machine for any reason.
a. Raise header, engage header lift cylinder stops, and lower header onto stops. b. Lower the reel fully.
D60 c. Adjust fore-aft reel position so that back end of cam disc is approximately between 4 and 5 on the arm decal.
Form 169441
Z
X
Y
118
NOTE
The reel has been adjusted at the factory to provide more clearance at the center of the reel than at the ends
(frown) to compensate for reel flexing.
e. Check all possible points of contact between points ‘Y’ and ‘Z’. Depending on reel fore-aft position, minimum clearance can occur at guard tine, hold-down or cutterbar. f. If adjustment is required, refer to following section.
Revision B
advertisement
Key Features
- Cuts and lays crop into uniform fluffy windrows
- Allows starting the harvest earlier
- Protects the crop from wind damage
- Gives you more flexibility in scheduling combine time
- Designed for self-propelled windrowers
- Optional hay conditioner available