advertisement
SECTION 8. MAINTENANCE AND SERVICING
8.9.8 REEL DRIVE U-JOINT - D60
CAUTION
D
To avoid bodily injury from fall of raised reel, always engage reel props before going under raised reel for any reason.
8.9.8.1 Removal - U-Joint
a. Lower header, raise reel, and engage reel props. b. Remove reel drive cover. Refer to Section 8.9.4
Reel Drive Chain - D60. c. Support inboard end of right reel with a front end loader and nylon slings (or equivalent set-up).
IMPORTANT
To avoid damaging or denting center tube, support reel as close as possible to the end disc.
B
C e. Remove six bolts (C) attaching U-joint (B) to driven sprocket (D).
NOTE
Right hand reel may need to be moved sideways for U-joint to clear reel tube.
B
A d. Remove four bolts (A) attaching reel tube to
U-joint (B).
8.9.8.2 Installation U-Joint
a. Position U-joint (B) onto driven sprocket (D) as shown, and install six bolts (C), and tighten. Do not torque at this time. b. Position RH reel tube against reel drive, and engage stub shaft into U-joint pilot hole. c. Rotate reel until holes in end of reel tube and
U-joint line up. d. Install four bolts (A), and torque to 70 - 80 ft·lbf
(95 - 108 N·m). e. Torque bolts (C) to 70 - 80 ft·lbf (95 - 108 N·m). f. Remove temporary reel support. g. Re-attach reel drive cover. Refer to Section 8.9.4
Reel Drive Chain - D60.
Form 169441
128
Revision B
advertisement
Key Features
- Cuts and lays crop into uniform fluffy windrows
- Allows starting the harvest earlier
- Protects the crop from wind damage
- Gives you more flexibility in scheduling combine time
- Designed for self-propelled windrowers
- Optional hay conditioner available