advertisement
SECTION 8. MAINTENANCE AND SERVICING
8.9.11 REEL SPEED SENSOR
To adjust and replace the self-propelled windrower reel speed sensor, proceed as follows:
CAUTION
To avoid bodily injury from fall of raised reel, always engage reel props before going under raised reel for any reason.
WARNING
A
B
Stop engine, and remove key before making adjustments to machine. A child or even a pet could engage the drive.
C
C
D
0.080 - 0.160 in
(2 - 4 mm) a. Removal
1. Disconnect sender wire (A).
2. Remove nut and bolt (B) attaching sender to support. b. Installation
1. Position sender (C) on support, and install bolt (B) and nut.
2. Connect sender wire at (A).
3. Adjust clearance between sensor and driven sprocket (D) to 0.080 - 0.160 in. (2 - 4 mm) by bending support.
Form 169441
131
Revision B
advertisement
Key Features
- Cuts and lays crop into uniform fluffy windrows
- Allows starting the harvest earlier
- Protects the crop from wind damage
- Gives you more flexibility in scheduling combine time
- Designed for self-propelled windrowers
- Optional hay conditioner available