advertisement
SECTION 8. MAINTENANCE AND SERVICING
8.4.2 NON-HINGED
a. To remove the endshield, press against latch in opening at (A) on inboard side of endsheet.
A b. Lift up on shield, pull out and back to remove shield.
8.4.2.1 Adjustments
NOTE
Plastic endshields are subject to expansion or contraction depending on large temperature variations. Latch pin can be adjusted to compensate for dimensional changes.
E
B
C
D c. To install shield, locate forward end in crop divider (B), and position shield over endsheet.
Pin (C) at top of endsheet must engage shield. d. Push in shield where shown (opposite latch), and shield will self-latch.
Form 169441
79
X
c. Adjust the pin assembly (E) to achieve the gap
‘X’ between the front end of the shield and the header frame in accordance with the following chart.
TEMPERATURE
Degrees ˚F ( ˚C)
25 (- 4)
45 (7)
65 (18)
85 (29)
105 (41)
125 (52)
145 (63)
165 (89) d. Tighten bolts (D).
GAP ‘X’
Inches (mm)
1.1 (28)
1.0 (24)
0.79 (20)
0.64 (16)
0.5 (12)
0.32 (8)
0.16 (4)
0
(continued next page)
Revision B
advertisement
Key Features
- Cuts and lays crop into uniform fluffy windrows
- Allows starting the harvest earlier
- Protects the crop from wind damage
- Gives you more flexibility in scheduling combine time
- Designed for self-propelled windrowers
- Optional hay conditioner available