Detachment. MacDon D50 & D60

SECTION 7. OPERATION

7.3.2 DETACHMENT

a. Fully lower the reel. b. Disconnect the reel hydraulics as follows:

E

E b. Connect reel hydraulics (E) as follows:

1. Check connectors, and clean if required.

F

G

H

1. Push in lock button (G), and pull handle (H) to disengage multi-coupler (E) from header receptacle.

H

G

E

2. Open cover (F) on header receptacle.

3. Push in lock button (G), and pull handle (H) to “half open” position.

4. Remove hose bundle with multi-coupler (E) from tractor, position onto header receptacle, and push handle (H) to engage pins on connector.

5. Push handle away from hoses until lock button (G) snaps out. c. Raise and lower header and reel a few times to allow trapped air to pass back to the reservoir.

2. Route hose bundle back onto windrower, and store multi-coupler (E) on hose support.

3. Close cover (F) on header receptacle.

(shown in previous column)

(continued next page)

Form 169441

24

Revision B

SECTION 7. OPERATION

c. Disconnect the header drive hydraulics as follows:

C

1. Disengage and rotate lever (C) counter clockwise to fully up position.

2. Disconnect electrical connector from header.

3. Disconnect hoses from header as follows:

K

J

A i. Line up slot (J) in collar with pin (K) on connector. ii. Push collar toward pin, and pull connector to disengage. iii. Install caps on connectors and hose ends (if equipped).

D

C

4. Route hose bundle (A) back onto hose support on windrower.

5. Rotate lever (C), and lock in down position.

6. Install cap (D) on electrical connector. d. Detach header from windrower. Refer to the

M150/M200 or M205 Self-Propelled Windrower

Operator’s Manual.

Form 169441

25

Revision B