advertisement
SECTION 8. MAINTENANCE AND SERVICING
8.8.2 REPLACING SPLIT DRAPER
The draper should be replaced or repaired if it is torn, missing slats, or cracked.
CAUTION
To avoid bodily injury from fall of raised reel, always engage reel props before going under raised reel for any reason.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, stop engine, remove key and engage lift cylinder locks before going under machine for any reason.
a. Insert draper into deck at outboard end, under the rollers. Pull draper into deck, while feeding it at the end. b. Feed in the draper until it can be wrapped around the drive roller. c. Similarly insert the other end into the deck over the rollers. Pull draper fully into the deck. d. Attach ends of draper with tube connectors (D). a. Raise reel, and engage reel props. b. Raise header, and install lift cylinder locks. c. Stand in draper opening, and move draper until draper joint is in work area.
NOTE
Deck can also be shifted towards center to provide opening at endsheet.
d. Release tension on the draper. Refer to previous section.
C
D e. Remove nuts (C), and tube connectors (D) at draper joint. f. Pull draper from deck.
Form 169441
110
C
D e. Install screws (C) with heads facing the center opening. f. Adjust tension. Refer to Section 8.8.1 Draper
Tension Adjustment.
Revision B
advertisement
Key Features
- Cuts and lays crop into uniform fluffy windrows
- Allows starting the harvest earlier
- Protects the crop from wind damage
- Gives you more flexibility in scheduling combine time
- Designed for self-propelled windrowers
- Optional hay conditioner available