ENDSHIELDS. MacDon D50 & D60

Add to My manuals
160 Pages

advertisement

ENDSHIELDS. MacDon D50 & D60 | Manualzz

SECTION 8. MAINTENANCE AND SERVICING

8.4 ENDSHIELDS

Single knife headers are fitted with a hinged endshield on the LH end of the header for easy access to the header drive. The RH end is not hinged, but is still removable.

Double knife headers are fitted with hinged endshields on both ends of the header.

8.4.1 HINGED

a. To open the hinged endshield, press against latch in opening at (A) on inboard side of endsheet.

A d. Push in shield where shown (opposite latch) and shield will self-latch.

8.4.1.1 Adjustments

NOTE

Plastic endshields are subject to expansion or contraction depending on large temperature variations. Latch pin can be adjusted to compensate for dimensional changes.

B b. Pull shield away from header, and swing it out and back behind the endsheet until the latch (B) engages the hook on the endsheet.

D

C c. To close shield, lift latch (B), and swing the shield forward until the front engages the crop divider

(C). b. Loosen bolts (D) on support.

F

Form 169441

E

77

c. Loosen bolts (E) on latch assembly (F).

(continued next page)

Revision B

SECTION 8. MAINTENANCE AND SERVICING

f. To achieve a snug fit between the aft end of the shield and header frame, loosen bolts (G), and adjust the latch (H) to re-position the shield.

X

d. Adjust the endshield to achieve the gap ‘X’ between the front end of the shield and the header frame, in accordance with this chart.

TEMPERATURE

Degrees ˚F (˚C)

GAP ‘X’

Inches (mm)

25 (- 4) 1.1 (28)

45 (7)

65 (18)

85 (29)

105 (41)

125 (52)

145 (63)

1.0 (24)

0.79 (20)

0.64 (16)

0.5 (12)

0.32 (8)

0.16 (4)

165 (89) 0 e. Tighten bolts (D) and (E) (shown on previous page).

J g. Loosen bolts (J) on endshield support, and adjust endshield to align with endsheet, as shown above. h. Tighten bolts (G) and (J).

8.4.1.2 Removal

K

Form 169441

H

G

78

b. Remove screw (K) at top of support tube. c. Lift endshield off support tube.

Revision B

advertisement

Key Features

  • Cuts and lays crop into uniform fluffy windrows
  • Allows starting the harvest earlier
  • Protects the crop from wind damage
  • Gives you more flexibility in scheduling combine time
  • Designed for self-propelled windrowers
  • Optional hay conditioner available

Related manuals

Frequently Answers and Questions

What is the purpose of MacDon D50 & D60 Harvest Headers?
They are designed to cut and lay crop into uniform fluffy windrows, which allows starting the harvest earlier, protects the crop from wind damage, and gives you more flexibility in scheduling combine time.
What types of crops can be harvested with MacDon D50 & D60 Harvest Headers?
They can be used to harvest grain, hay, and specialty crops.
Do MacDon D50 & D60 Harvest Headers work with all self-propelled windrowers?
Yes, they are designed to work with self-propelled windrowers.
Can I use a hay conditioner with MacDon D50 & D60 Harvest Headers?
Yes, an optional hay conditioner is available.

advertisement

Table of contents