MLX Non-Display Telephone Some dialing sequences need special. AT&T MERLIN LEGEND Release 3.1, MERLIN LEGEND Release 4.0

Programming Special Characters

MLX Non-Display Telephone

Some dialing sequences need special characters. For example, you would press Hold to insert a pause in a dialing sequence after a dial-out code to allow the system to seize an outside line before dialing the number. A pause can also be used to separate a phone number from an extension number.

Table H–3. Special Characters for MLX Non-Display Telephone

Press...

Drop

Hold

Conf

##

#

Means...

Stop. Halts the dialing sequence to allow the system to respond.

Pause. Inserts 1.5 second pause in the dialing sequence. Multiple consecutive pauses are allowed.

Flash. Sends a switchhook flash. Must be the first entry in the dialing sequence.

End of Dialing for Extension Programming only.

Used at the end of a dialing sequence to indicate you have finished dialing or to separate one group of dialed digits from another, for example, account codes from number dialed.

End of Dialing. Used to signal the end of the dialing sequence or to separate group digits, for example, account code from number dialed.

System Programming H–3