Preparation. BOMANN KM 1395 CB , KM 1395

Preparation

Please refer to our overviews on page 3 and 4.

1. Assemble the bowl without tools.

2. Cover the uptake for the spiral housing with the cover

(15).

3. Fill in the crushed ingredients into the mixing bowl.

4. Press the lid firmly onto the mixing vessel. It has to snap in audibly.

5. Press the lid firmly on the mixing bowl. Set the cap into the filling opening and tighten it by turning it anticlockwise.

Operation of the Mixer

6. Make sure that the arm is lowered and locked.

7. Remove the safety cover (6) from the shaft drive of the mixer motor. Press and slide the grooved surface simultaneously.

8. Place the mixing bowl on the drive shaft of the mixing engine. Set the mixing jug with the arrow over the dot

of the base unit. Turn the mixing jug clockwise up to the stop. The two arrows and must be one above the other.

9. Plug the power cord into an approved mains outlet.

10. Select a speed level.

NOTE:

•

Short-term operation:

Operate the appliance no longer than 2 minutes when mixing. Allow it to cool down for 1 minute before using it again.

•

To refill ingredients

, turn off the appliance. Remove the lock by turning it clockwise and pulling it up. Continue operation only with the refill opening closed.

Complete Operation

1. Turn the rotary knob anticlockwise until the display shows

“ ”.

2. Disconnect the power plug.

3. Remove the mixing bowl.

4. Lift the lid before pouring out the contents. Place a finger in the grip recess on the lid (2). Press the unlock button

(4) down and at the same time pull the lid up.

5. Clean the parts used as described under

“Cleaning”

.

6. Cover the drive shaft of the mixing engine with the safety cover.

IMPORTANT NOTE:

Never keep citrus juices or acidic foods in metal bowls.

Cleaning

WARNING:

• Always disconnect the power plug before cleaning.

• Never immerse the appliance in water for cleaning. It could cause an electric shock or fire.

• The knives in the mixing bowl and the meat grinder are sharp!

There is a

risk of injury

! Proceed carefully when disassembling, cleaning and assembling the individual parts.

CAUTION:

• Do not use wire brushes or other abrasive objects.

• Do not use any sharp or abrasive cleaning agents.

Accessories of the Kneading Machine and the Meat

Grinder

Motor Housing

For cleaning of the housing, only use a damp cloth and mild detergents.

CAUTION:

The components are not suitable for cleaning in the dishwasher. Under the influence of heat and strong detergents, they could deform or discolour.

• Components that have come into contact with food, can be cleaned in soapy water.

• Allow the parts to dry thoroughly before assembling the appliance again.

63

KM1395CB_IM 22.06.17