If the Delivery Feeder Unit Is Not Installed Correctly. Canon Color imageCLASS MF9280Cdn, Color imageCLASS MF9220Cdn

12-22

If the Delivery Feeder Unit Is Not Installed Correctly

If the Delivery Feeder Unit Is Not Installed

Correctly

If the delivery feeder unit is not installed correctly, an error code <E000012> appears on the display. Follow the procedure below to install the delivery feeder unit correctly. If the error code does not disappear after the delivery feeder unit is installed correctly, contact Canon

Customer Care Center.

–

–

–

–

–

You have to remove the delivery feeder unit and re-install the delivery feeder unit correctly.

When you remove the delivery feeder unit, you have to turn the main power switch OFF.

Sending or receiving documents cannot be done when the main power switch is OFF or the power cord is disconnected.

If the main power switch is turned OFF, all jobs waiting in the print queue will be erased.

Documents received into memory and documents stored for delayed send will be retained for approximately 60 minutes after the power cord has been disconnected.

1 Turn OFF the main power switch and disconnect the power cord.

3 Push the levers (A) on both sides of the delivery feeder unit and remove the delivery feeder unit gently, holding it by the tabs (B).

Make sure that the Processing/Data Indicator is turned off and check the display to confirm that a job is not being processed.

2 Open the front cover.

If you are using the stack bypass tray, close it before opening the front cover.

Open the front cover gently holding the handle

(A).

Do not place any object on or touch the transfer belt (A) of the delivery feeder unit. The transfer belt (A) of the delivery feeder unit is supplied with a function that cleans itself, therefore, do not clean the belt even when the toner is on it. If the delivery feeder unit is broken or transfer belt (A) is damaged, this may result in misfeeds or deterioration in print quality.

If the Delivery Feeder Unit Is Not Installed Correctly

5 Confirm that the triangle marks (A) on the delivery feeder unit are aligned with the triangle marks (B) on the machine.

4 Install the delivery feeder unit so that the protrusions (A) of the delivery feeder unit fit into the guides (B) and click into place.

6 Close the front cover

Close the front cover gently holding the handle.

7 Reconnect the power cord and turn on the main power switch.

12-23