advertisement
Installing Options
Available Options
This section describes how to install options.
By installing options, you can improve the printer performance and have an expanded variety of features to use. For the specifications of each option, see
Maintenance Guide.
• Before installing options, the machine should be turned off and unplugged for at least an hour. Components inside the machine become very hot, and can cause a burn if touched.
• Before moving the machine, unplug the power cable from the outlet. If the cable is unplugged abruptly, it could become damaged. Damaged plugs or cables can cause an electrical or fire hazard.
• When lifting the machine, use the grips on both sides. The machine could break or cause an injury if dropped.
❒ The voltage rating of the connector for options is 24 V DC or less.
Option Installation Flow Chart
We recommend you install multiple options in the following order:
A
Attach the paper feed unit (Paper Feed Unit Type 3000).
Attach the paper feed unit to the bottom of the printer.
You can attach up to two paper feed unit. Up to 1690 sheets of paper can be loaded.
B
Install the duplex unit (AD440) to the back of the front cover.
C
Install the SDRAM module (Memory Unit Type D 128MB, Memory Unit
Type E 256MB).
Install the module to the SDRAM module slot on the controller board.
There are two types of memory unit: 128 MB and 256 MB.
D
Install the printer hard disk (Printer Hard Disk Type 3000).
Install the printer hard disk to the controller board.
E
Install the user account enhance unit (User Account Enhance Unit Type
E).
Install the module to the user account enhance unit slot of the controller board.
G1398502_1.00
Copyright © 2005
44
advertisement
Related manuals
advertisement