advertisement
Replacing Consumables and Maintenance Kit
Replacing the Fusing Unit
• The inside of this machine gets very hot. Do not touch parts labelled
“v”(hot surface). Touching “v” labelled parts (hot surface) could result in burns.
• The fusing unit gets very hot. When installing a new fusing unit, turn off the printer and wait about 30 minutes. Then you can install the new fusing unit.
Handling the unit before it has fully cooled down (30 mins) could result in burns.
• Do not pull out the fusing unit forcefully. Doing so may cause the unit to fall and result in injury.
• Only the handle of the fusing unit is safe to touch. Touching other areas may result in burns.
Replace the fusing unit when the following message appears on the display: or
Replace Fusing
Unit soon
Replace
Fusing Unit
Check the contents of the box for the following items:
❖ Fusing Unit
44
Replacing Consumables and Maintenance Kit
❖ Transfer Roller
❒ Be sure to make the maintenance setting using the control panel after replacing the fusing unit. The procedure is complete only when the maintenance setting is made.
A
Turn off the power, and then unplug the power cable.
❒ After power off, wait 30 minutes for the fusing unit to cool before handling it.
B
Open the front cover by pushing the front cover release button.
C
Pinch the connector lever, and then pull out the connector.
45
Replacing Consumables and Maintenance Kit
D
Push the green release buttons on the left and right outwards to unlock the fusing unit.
E
Remove the fusing unit carefully.
F
Take the new fusing unit from out from its box.
G
Place the unit as shown, and then carefully insert the new fusing unit.
46
Replacing Consumables and Maintenance Kit
H
Carefully push in the fusing unit until it clicks into position, and then check that the unit is locked.
I
Push in the connector.
J
Open the transfer roller cover.
47
Replacing Consumables and Maintenance Kit
K
Turn the green part in the direction of the arrow, and then remove the transfer roller.
L
Take out the new transfer roller.
❒ Do not touch the roller part.
M
Hold the green part as shown, and then insert the transfer roller into the printer.
❒ The end with the longer shaft must be to the left.
48
advertisement
Related manuals
advertisement