spoolsw. Ricoh CLP22, LP222cn

Monitoring and Configuring the Printer

• If you select “auto”, the print job will be encrypted when encryption is possible.

• If you select “on”, Clear Text communication is not possible, and encryption password must be set before encryption communication can be used.

❒ Encryption is possible when the security option is installed correctly and the password is specified.

sntp

The printer clock can be synchronized with a NTP server clock using Simple Network Time Protocol (SNTP). Use the “sntp” command to change SNTP settings.

❖ View settings

msh> sntp

❖ NTP server address configuration

You can specify the IP address of the NTP server.

msh> sntp server “IP_address”

❖ Interval configuration

msh> sntp interval “polling_time”

• You can specify the interval at which the printer synchronizes with the operator-specified NTP server. The default is 60 minutes.

• The interval can be entered between 16 and 16,384 minutes.

• If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After that, the printer does not synchronize with the NTP server.

❖ Time-zone configuration

msh> sntp timezone “+/-hour_time”

• You can specify the time difference between the printer clock and NTP server clock. Time is in 24-hour format.

spoolsw

Use the “spoolsw” command to configure Job Spool settings.

You can only specify diprint, lpr, ipp, ftp and smb protocol.

• The “spoolsw” command for configuring Job Spool settings is available only when the optional hard disk is installed.

❖ View settings

The Job Spool setting appears.

202