advertisement
Making Printer Settings Using the Control Panel
Maintenance Menu
You can set printing conditions such as density and calibration, and printer management such as formatting the optional hard disk unit.
Changing the maintenance menu
This section explains changing the maintenance menu using examples.
HD Format
Follow the procedure below to format the optional hard disk unit after initial setup.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {T} or {U} key to display [Maintenance], and then press the {#
Enter} key.
C
Press the {T} or {U} key to display [HD Format], and then press the {# En-
ter} key.
D
Read the HD format confirmation message, and then press the {# Enter} key to start formatting.
The optional hard disk unit is formatted, and the rebooting message appears.
E
Turn off the printer's power. After a few seconds, turn the power on again.
The optional hard disk unit is now formatted and ready to use.s
132
Making Printer Settings Using the Control Panel
❒ If the [HD Format] button is not displayed, the optional hard disk unit is not properly installed. Reinstall the optional hard disk unit. For details about the optional hard disk unit, see Setup Guide. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.
Displaying the signal strength
Follow the procedure below to check the IEEE 802.11b (wireless LAN) signal on the [Maintenance] menu.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {T} or {U} key to display [Maintenance], and then press the {#
Enter} key.
C
Press the {T} or {U} key to display [WL.LAN Signal], and then press the {#
Enter} key.
Check the display for result.
D
Press the {Escape} key.
The initial screen appears.
❒ If [WL.LAN Signal] is not displayed, [IEEE 802.11b] has not been selected for
[LAN Type] in [Network Setup] on the [Host Interface] menu. Select [IEEE
802.11b] for [LAN Type], and then check that [WL.LAN Signal] is displayed on the [Maintenance] menu again.
❒ Signal status can be measured in [Infrastructure] under [Comm. Mode] of the wireless LAN. If [Ad hoc] or [802.11Ad hoc] is selected in [Comm. Mode], signal status cannot be measured. To measure signal status, select [Comm. Mode] in [Infrastructure] under [IEEE 802.11b] on the [Host Interface] menu.
❒ Every time you press the {# Enter} key, the signal is updated.
133
advertisement
Related manuals
advertisement