Attaching IEEE 1394 Interface Board Type B. Ricoh CLP22, LP222cn

Installing Options

Attaching IEEE 1394 Interface Board Type

B

• Do not touch the inside of the controller board compartment. Doing so may cause a malfunction or a burn.

❒ The 1394 interface board uses “IP over 1394” and “SCSI print”. Operating system-compatible connection methods are as follows (IEEE 1394 cannot be used with Windows 95/98 and Windows NT 4.0):

• Windows Me

“IP over 1394”

• Windows 2000

“SCSI print”

• Windows XP, Windows Server 2003

“IP over 1394”, “SCSI print”

❒ Under Windows 2000, the 1394 interface board can only be used with Service

Pack 1 or later. The client cannot install the printer driver without using an account that has administrators access rights.

❒ Before touching the 1394 interface board, ground yourself by touching something metal to discharge any static electricity. Static electricity can damage the

1394 interface board.

❒ Do not plug or unplug the 1394 interface cable while installing the printer driver.

❒ Use the 1394 interface cable that comes with 1394 interface board.

Check the package contains the following:

❖ IEEE 1394 Interface Board Type B

70

Installing Options

❖ Interface Cable (6 × 6 pins)

❖ Interface Cable (6 × 4 pins)

Turn off the power, and then unplug the power cable.

Loosen the two screws and remove the cover of the 1394 interface board installation unit.

The removed cover and two screws are not used when installing the 1394 interface board.

Fully insert the 1394 interface board.

71

Installing Options

Make sure that the 1394 interface board is firmly connected to the controller board.

Tighten the two screws to secure the 1394 interface board.

❒ After finishing installation, check the 1394 interface board is installed properly: print the configuration page from the “List/Test Print” menu. If it is installed properly, you will see “IEEE1394 ” for “Controller Option”.

❒ If the 1394 interface board is not installed properly, reinstall it from the start of the procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.

For details about printing the configuration page, see p.40 “Test Printing” .