Using NetWare. Ricoh CLP22, LP222cn

Using a Printer Server

Using NetWare

This section describes the setting procedure for network printers in the NetWare environment. In the NetWare environment, you can connect the printer as a

“print server” or “remote printer”.

❖ Setting procedure

• When using the printer as a print server

Installing SmartDeviceMonitor for Admin

Setting the network interface board.

C Turning the printer off and then back on.

• When using the printer as a remote printer

Installing SmartDeviceMonitor for Admin.

Setting the network interface board.

Setting NetWare.

Starting the print server.

❒ This procedure assumes an environment is already prepared for normal Net-

Ware running the printing service setting.

❒ The procedure is explained with the following example settings:

• File server’s name …CAREE

• Print server’s name …PSERV

• Printer’s name …R-PRN

• Queue name …R-QUEUE

❖ Using SmartDeviceMonitor for Admin

To use the printer in a NetWare environment, use SmartDeviceMonitor for Admin to set the NetWare printing environment.

❒ The NetWare Client provided by Novell is required to set the printing environment using SmartDeviceMonitor for Admin under the following environments:

• NDS mode in Windows 95/98/Me

• NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0

For details about installing SmartDeviceMonitor for Admin, see p.168 “Installing SmartDeviceMonitor for Admin” .