Attaching Paper Feed Unit Type. Ricoh CLP22, LP222cn

Installing Options

Attaching Paper Feed Unit Type 3000

When installing multiple options, install the paper feed unit first.

• The printer weights approximately 32 kg (70.5 lb.). When moving the print- er, use the inset grips on both sides, and lift slowly. The printer will break or cause injury if dropped.

• Lifting the paper feed unit carelessly or dropping it may cause injury.

❒ The paper feed unit weighs approximately 7.5 kg (16.5 lb).

❒ Up to two paper feed units can be attached to the printer.

❒ When two paper feed units are installed, they are identified as “Tray 2” and

“Tray 3” starting from the upper unit.

❒ Before using the new paper feed unit, you must make settings in the printer driver.

Turn off the power, and then unplug the power cable.

Check the package contains the following:

❖ Paper Feed Unit / Paper tray (inside the Paper Feed Unit)

Remove the adhesive tape.

47

Installing Options

Hold the paper feed unit as shown in the illustration, and then place it on a flat surface near where the machine is to be installed.

❒ Make sure you have enough space to access the back of the printer.

Pull the paper tray out of the paper feed unit until it stops. Lift it slightly, and then pull it fully out. Place the paper tray on a flat surface.

Remove the adhesive tape and packing material.

Slide the paper tray fully into the paper feed unit.

48

Installing Options

Lift using the inset grips on both sides of the printer.

Align the printer with the two upright pins on the paper feed unit, and then lower it slowly.

❒ Be sure not to place the printer on the paper feed unit cable.

49

Installing Options

Connect the paper feed unit cable securely to the socket inside the printer.

To connect two paper feed units, connect the paper feed unit cable securely to the socket inside the paper feed unit

❒ Before using the new paper feed unit, you must make settings in the printer driver.

❒ When moving or transporting the printer, make sure to unplug the paper feed unit connector. For more information, see “Moving and Transporting the Printer” in the Maintenance Guide.

❒ When moving the printer, remove the paper feed unit.

❒ After finishing installation, check the paper feed unit is installed properly: print the configuration page from the “List/Test Print” menu. If it is installed properly, you will see “Tray 2” or “Tray 2, Tray 3” for “Options”.

❒ If the paper feed unit is not installed properly, reinstall it from the start of the procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.

For details about printing the configuration page, see p.40 “Test Printing” .

See “Loading Paper”, Maintenance Guide.