autonet. Ricoh CLP22, LP222cn

Monitoring and Configuring the Printer

• Timeout value becomes ineffective.

autonet

Use the “autonet” command to configure AutoNet parameters.

❖ View settings

The following command displays the current AutoNet settings: msh> autonet

❖ Configuration

You can configure AutoNet settings.

msh> autonet {on|off}

• {on} means “active” and {off} means “inactive”.

❖ Current interface priority configuration display

msh> autonet priority

❖ Interface priority configuration

msh> autonet priority “interface_name”

• You can give interface's AutoNet parameter priority.

• Priority settings are available when multiple interfaces are installed.

• ip1394 can be specified only when the IEEE 1394 interface is installed.

• wlan can be specified only when the IEEE 802.11b interface is installed.

Interface name ether ip1394 wlan

Interface configured

Ethernet interface

IEEE 1394 interface

IEEE 802.11b interface

❒ If an interface is not selected, the current interface connection settings remain in effect.

For details about AutoNet, refer to autonet parameters.

btconfig

Use the “btconfig” command to make Bluetooth settings.

❖ View settings

Bluetooth settings are displayed.

msh> btconfig

183