User Settings for SSL (Secure Sockets Layer). Ricoh CLP22, LP222cn

Appendix

E

Click [Install].

F

Enter the contents of the server certificate.

In the displayed field, enter the contents of the server certificate issued by the certificate authority.

For details about the displayed items and selectable items, see Web Image

Monitor Help.

G

Click [OK].

[Installed] appears under [Certificate Status] to show that a server certificate for the printer has been installed.

Enabling SSL

After installing the server certificate in the printer, enable the SSL setting.

This procedure is used for a self-signed certificate or a certificate issued by a certificate authority.

A

Open a Web browser.

B

Enter “http://(printer's-address)/” in the address bar to access the printer.

C

Select Administrator mode.

For details about selecting Administrator mode in Web Image Monitor, see p.164 “Access in the Administrator Mode” .

D

Click [Configuration], then click [Security], and then click [SSL/TLS].

The [SSL/TLS Settings] page appears.

E

Click [Enable] for [SSL/TLS].

F

Click [Apply].

The SSL setting is enabled.

❒ When using SSL, enter "http://(machine's-address)/" to access the printer.

For this to work, Internet Explorer 5.5 or later, or Netscape 7.0 or later must be installed on your computer.

User Settings for SSL (Secure Sockets Layer)

If you have installed a server certificate and enabled SSL (Secure Sockets Layer), you need to install the certificate on the user’s computer.

289