When using the PostScript 3 Printer Driver. Ricoh CLP22, LP222cn

Preparing for Printing

The details shown in [Comment:], [Driver:], and [Port:] vary depending on the operating system, printer model, and port.

H

Click [Port:], and then click [Add].

I

Click [Network Printer], and then click [OK].

J

Double-click the name of the NetWare file server on the network tree.

The created queue is displayed.

K

Select the print queue, and then click [OK].

L

Check that the port of the selected printer is displayed in [Port:].

M

Click [Finish].

The printer driver installation starts.

N

Click [Finish] in the [Component selection] dialog box.

O

Click [Finish] in the [Introduction complete] dialog box.

P

In the [Printers] window, open the printer properties.

Under Windows XP or Windows Server 2003, open the printer properties from the [Printers and Faxes] window.

Q

On the [Printer Settings] tab, clear the [Form Feed] and [Enable Banner] check boxes.

Under Windows 2000/XP, Windows Server 2003, or Windows NT 4.0, click the [NetWare setting] tab.

Do not select these check boxes since they are automatically selected by the printer driver. If you select the check boxes, the printer may not print correctly.

R

Click [OK] to close the printer properties dialog box.

❒ The protocol is set to inactive as default. Enable it using Web Image Monitor or Telnet

When using the PostScript 3 Printer Driver

Follow the procedure below to set up the PostScript 3 printer driver.

A

In the [Printers] or [Printers and Faxes] window, open the printer properties.

B

Click the [PostScript] tab.

❒ When using Windows 2000/XP or Windows NT 4.0, click the [Device Set-

tings] tab, and then proceed to step to clear the check box.

50