783620H / 1013 4. DISPLAY FEATURES
Analyze Spectrum duplicates the Entire Spectrum in Memory... command on the
Analyze menu (see Section 5.5.4).
The right-most part of the toolbar is a drop-down list of the available Detectors (Fig. 47). To select a Detector or the buffer, click in the field or on the down-arrow beside it to open the list, then click the desired entry. The sidebar will register your selection. Finally, note that as you pause the mouse pointer over the center of a toolbar button, a pop-up tool tip box opens, describing the button’s function (Fig. 48).
Fig. 48. Roll-Over
Toolbar Tool Tips.
Fig. 47. Drop-Down Detector
List.
4.4. Using the Mouse
The mouse can be used to access the menus, toolbar, and sidebars; adjust spectrum scaling; mark and unmark peaks and ROIs; select Detectors; work in the dialogs — every function in
GammaVision except text entry. The following sections describe specialized mouse functions.
4.4.1. Moving the Marker with the Mouse
To position the marker with the mouse, move the pointer to the desired channel in the Expanded Spectrum View and click the left mouse button once. This will move the marker to the mouse position. Click in the Full Spectrum View to move the expanded view to that place. This is generally a much easier way to move the marker around in the spectrum than using the arrow keys and accelerators, although you might still prefer some keyboard functions for specific motions.
4.4.2. The Right-Mouse-Button Menu
Figure 49 shows the right-mouse-button (context) menu. To open it, position the mouse pointer in the spectrum display, click the right mouse button, then use the left mouse button to select from its list of commands. Not all of the commands are available
Fig. 49.
49
