10.1.1.2. Errors. ORTEC A66-BW GammaVision

GammaVision

®

v7 (A66-BW) 783620H / 1013

The loop counters are: 0, 10 and 25.

The loop counters are: 1, 11 and 26.

The loop counters are: 2, 12 and 27.

The loop counters are: 3, 13 and 28.

The loop counters are: 4, 14 and 29.

Note that custom variable values cannot be embedded in custom variables. For example, the expression ‘$(Loop$(Variable))’ is invalid.

10.1.1.2. Errors

If an error is encountered in running a

.JOB

file, the execution of the file stops and control returns to GammaVision. An error code appears in the JOB Control... dialog; these are described in Appendix C.

10.1.1.3. Ask on Start and Ask on Save

If the appropriate Ask on Start (see Acquire/Acquisition Settings...) or Ask on Save (see

File/Settings...) fields are turned on, GammaVision will ask the corresponding questions when

START or SAVE commands are executed in the

.JOB

file. This means that execution of the

.JOB

file stops until the entry is made.

The ASK commands will also stop the

.JOB

file and prompt you to enter the requested information. The

.JOB

file will continue when you click OK or press <Enter> on the dialog. The input is used or stored immediately, before the next JOB instruction, except for the ASK_SPECTRUM command.

NOTE

If you choose Cancel when responding to an ask-on-start or ask-on-save prompt, the

JOB will terminate at that point.

10.1.1.4. Password-Locked Detectors

When

.JOB

files are used with locked Detectors, the first time a destructive command is used on the locked Detector, you will be prompted for the password. Alternatively, you can use the

ASK_PASSWORD command at the beginning of the JOB. From then on while the

.JOB

file executes, the password is retained and you will not receive a prompt. When the

.JOB

file quits, the password is forgotten.

10.1.1.5. .JOB Files and the Multiple-Detector Interface

GammaVision allows you to open eight Detector windows and eight buffer windows at one time.

However, there is no limit on the number of Detectors that can be operated using

.JOB

files, and only one JOB at a time can run in a single instance of GammaVision. A Detector window opens

386